039 Bq/g) measured at the upstream Munroe Falls dam pool (Peck et

039 Bq/g) measured at the upstream Munroe Falls dam pool (Peck et al., 2007). The bedrock beneath the Gorge Dam pool sediment is sandstone and shale of the Cuyahoga Group, whereas the Munroe Falls site is underlain by the quartz-rich Sharon Formation. Shale often contains more 238U (the grand grandparent to 210Pb) than sandstone, and the difference in bedrock type may account for the slight difference in background values between these nearby sites. The core top (0 cmblf) was set to the time of core PS-341 mouse collection (year 2011.4). 9 cm of gravel at the base of core C4 is interpreted as a fluvial deposit predating the

construction of the dam. Overlying the gravel at 545 cmblf is the base of the impoundment mud deposit. The sample at 488.1 cmblf has an unrealistic 210Pb age (1890) that predates dam construction (Fig. 7). Therefore the age model is estimated by linear interpolation between the 210Pb CHIR-99021 supplier sample at 443.6 cmblf (1928) and the onset of inferred impoundment sedimentation at 545 cmblf (1912)(Fig. 7). Deep in the core the 210Pb values approach background; thus, the ages have larger uncertainty. As described in Section 3.3, bathymetric maps and sediment cores were used to obtain a sediment volume estimate. Core C4 was collected close to cross section 3 (Fig. 2) and contains

4.98 m of sediment between the 2010 and 1918 210Pb dated horizons. This amount of sediment agrees closely with the 4.86 m difference between the 1918 and 2010 bathymetric surfaces at cross section 3. The total sediment volume is estimated at 765,000 m3 and, based upon an average sediment dry bulk density (0.58 g cm−3), has an approximate mass of 444,000 tonnes. To examine changes in sediment accumulation rate we followed the method of Evans and Heller (2003). The mass accumulation PLEKHB2 rate (kg m−2 yr−1) for core

C4 was calculated by multiplying the sedimentation rate, determined from 210Pb dating, by the dry bulk density (measured at a 2 cm interval corresponding to an average time step of 0.4 yr). The core C4 mass accumulation rate was then multiplied by the dam pool surface area (160,000 m2) to estimate the total sediment mass deposited at each dated horizon (Fig. 8). Summing all 99 years of mass accumulation yielded a total of 508,000 tonnes of impoundment sediment. This value is only 14% greater than the mass obtained by simply multiplying the total volume by an average sediment density as reported above. Our method of multiplying the core C4 mass accumulation rate by the dam pool area assumes that the sediment thickness and sediment type at core site C4 is uniform throughout the impoundment. We believe that these assumptions are not severe limitations. Downstream of Front Street Bridge the C4 thickness is representative of much of the impoundment. However, between profiles 9 and 14 the sediment can be up to 8–10 m thick (Fig. 5).

Leave a Reply

Your email address will not be published. Required fields are marked *

*

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>