2 cm-1) For all of the Raman spectra, the excitation power and s

2 cm-1). For all of the Raman spectra, the excitation power and spot size were about 2.5 mW and 1 μm, respectively. In order to investigate the homogeneity of the ZnO/CdTe core-shell NW arrays at micron and submicron scales, a Marzhauser Wetzlar motorized stage (Wetzlar, Germany) was used with a lateral step resolution of 100 nm either in steps of 200 nm or 3 μm. Solar cell fabrication and photovoltaic Ilomastat in vivo performances In order

to investigate the photovoltaic properties of as-grown and annealed ZnO/CdTe core-shell NW arrays, CuSCN as a wide bandgap p-type semiconductor was deposited by impregnation. A saturated solution of CuSCN was initially prepared by dissolving 50 mg of CuSCN in 10 mL of n-propyl sulfide. The solution of 0.04 M was then spread over the ZnO/CdTe core-shell NW arrays held on a hot plate kept at 100°C. The solar cells were completed by evaporating a 40-nm-thick gold contact with an Edwards evaporator (Gennevilliers, France). Their photovoltaic properties were recorded under 100 mW/cm2 AM 1.5G simulated sunlight (model 96000, Oriel Instruments,

Irvine, CA, USA). The solar simulator had previously been calibrated by using a NREL certified solar cell (Spectra Nova, Ontario, Canada). The external quantum efficiency (EQE) measurements were achieved by using a halogen lamp as the light source and a Newport monochromator (Cornestone 130, Irvine, CA, USA). The acquisition was collected via a lock-in amplifier system. A silicon calibrated diode was used for determining the absolute incident-light check details intensity. In order to analyze the spatial distribution of photo-generated charge carriers, the optical generation rate was computed with a three-dimensional (3D) rigorous coupled wave analysis Baf-A1 datasheet (RCWA) tool developed at IMEP-LAHC [44]. The optical generation rate basically represents the number of photo-generated charge carriers

per unit volume and unit time. The 3D monochromatic generation rate was calculated for each find more wavelength (λ), ranging from λ = 300 nm to λ = 820 nm with a λ step of 20 nm, from: (1) where λ, E, and h are the permittivity, electric field amplitude, and Planck constant, respectively. r, θ, and z are the variables of the cylindrical coordinate system used. The optical databases were taken from [20, 45, 46], G Rey et al., unpublished work] for ZnO, CdTe, CuSCN, and FTO, respectively. The 3D monochromatic generation rate was averaged over a circle perimeter following the procedure of [47, 48]. (2) Eventually, the 3D polychromatic generation rate was computed by weighting the 3D monochromatic generation rates with the solar irradiance spectrum (I AM1.5G taken from [49]): (3) where I incident is the light intensity shining the ZnO/CdTe core-shell NW arrays from the FTO/glass substrate side. Results and discussion Effects on the structural ordering of ZnO/CdTe core-shell NW arrays The structural properties of the as-grown and annealed ZnO/CdTe core-shell NW arrays are presented in Figures  1, 2 and 3.

Comments are closed.