0025 for the undiluted sample and twofold dilutions for each following sample). At the lowest densities even small numbers Poziotinib supplier of bacterial cells sticking to the walls of the tubes will introduce high variability. This problem can be avoided

by systematically vortexing the bacteria immediately before transferring to new tubes or to the microtiter plate where the growth will be measured. Growth assays were conducted in clear flat-bottom BD Falcon 96-well plates (BD Biosciences, San Jose, CA), containing 8 replicates of 150 μL per sample (or 4 replicates in the case of IND with and without C4-HSL). The plates were incubated at 37°C in a Tecan Infinite M1000 plate reader (Tecan US Inc., Durham, NC) set to “”incubation mode”" with orbital shaking of 4 mm amplitude. Optical density at 600 nm (OD600) and GFP fluorescence (λexcitation =

488 nm, λemission = 525/40 nm) were measured every 10 minutes for the duration of the assay (32 h). Anthrone assay to quantify rhamnolipids After each assay, the eight replicates of each sample were pooled together in a microcentrifuge tube. The cells were spun down at 7,000 rcf for 2 minutes. Pooling the replicates will lead to considerable foaming because of rhamnolipids in the supernatant. This foam contains a significant amount of rhamnolipids and must therefore be collected. 750 μL of the supernatant were transferred to a new microcentrifuge tube. Rhamnolipid extraction was then carried out twice via liquid-liquid extraction using 750 μL of chloroform:methanol at 2:1 (v:v) each time. When experiments had only four replicates we used a variation of this extraction protocol, transferring 500 μL of the supernatants and extracting Ceritinib solubility dmso with 500 μL of chloroform:methanol each time. The organic phases of both extractions were pooled and then evaporated to dryness in a Vacufuge Concentrator (Eppendorf, Hauppauge, NY) at 60°C. Each sample

was subsequently re-suspended in 100 μL of pure methanol, so that the final rhamnolipid concentration is 7.5 × higher than in the initial culture (or 5 × for experiments with 4 replicates). Quadruplicate samples of 20 μL each were then prepared together with quadruplicate samples of an L-rhamnose (Indofine Chemical Company, Hillsborough, Fossariinae NJ) ladder in a Thermogrid 96-well PCR plate (Denville Scientific, Inc., Metuchen, NJ). The plate was put in iced water and 200 μL of anthrone (Alfa Aesar, Ward Hill, MA) solution (0.1% (w/v) in 70% (v/v) H2SO4) were added to each sample before heating the entire plate to 80°C for 30 minutes. At this point the degree of blueness indicates the amount of rhamnose in a sample. 200 μL of each sample were then transferred to a clear flat-bottom 96-well plate and the absorbance was measured at 630 nm. The absorbance levels were converted to rhamnose concentration using the rhamnose calibration values. Computational alignment of growth curves All growth curve analysis and plotting was carried out in Matlab (the Mathworks, Inc., Natick, MA).